|
 |
|
  |
|
|
TLP RF & Microwave Laminate
Characteristics
Dimensionally Stable
Low Loss
Low Moisture Absorption
High Copper Peel Strength
Uniform & Consistent DK
Low Cost, High Performance Base Material (minimum order required)
Applications
Automotive Radar
mm wave Applications
Sensors
Base Station Antennas: for GSM, UMTS, 3G, PCS, PCN, WCDMA, TD-SCDMA, EDGE, CDMA2000, HSDPA, MIMO, LTE, UMB
High Power Amplifier, TMA, TMB, LNA: for GSM, UMTS, 3G, PCS, PCN, WCDMA, TD-SCDMA, EDGE, CDMA2000
High Frequency Communication
Introducing TLP
Taconic has over 35 years of experience coating fiberglass fabric with PTFE
(polytetrafluoroethylene). This enables Taconic to manufacture copper clad PTFE/woven
glass laminates with exceptionally well controlled electrical and mechanical properties.
Taconic TLP laminates are manufactured from woven fiberglass fabric coated wIth PTFE
interleaved with thin sheets of pure PTFE. The woven matrix produces a more mechanically
stable laminate with a more uniform dielectric constant (DK) than traditional non-woven
products. The exceptionally low dissipation factor extends the usefulness of this product
to 35 GHz and above.
The dielectric constant range is 2.17 to 2.40. For most thicknesses, the dielectric constant
can be specified anywhere within this range with a tolerance of ± 0.03. In the low dielectric
constant range, the dissipation factor is approximately 0.0009 when measured at 10 GHz.
Please continue for a complete product listing.
TLP laminates can be sheared, drilled, milled and plated using the accepted methods for
PTFE/woven fiber-glass laminates. The laminates are dimensionally stable and are resistant
to the solvents and reagents used during fabrication. TLP laminates are being used in composite
multi-layer circuitboard applications.
Typical applications for TLP laminates include mobile communications systems, sensors, antennas,
RF components, and automotive radar.
TLP laminates are generally ordered clad on one or both sides with 1/2, 1, and 2 oz.
electrodeposited copper. Contact our Customer Service Department for alternate claddings.
Our TLP laminates meet the latest revision of IPC-4103.
TLP laminates are tested in accordance with IPC-TM-650. A certificate of compliance containing
lot-specific test data accompanies each shipment.
 Typical Values
Download PDF-File
Back to Products Overview
|
|
|
|
|
|
|